// Slackware

UEFI dual-boot safety checklist

Protect an existing Windows installation when adding Linux.

Installing Linux beside Windows is possible, but partitioning and boot changes are high impact. This guide is a preflight checklist, not a substitute for the model-specific installer instructions.

Before touching partitions

  1. Back up personal data to a separate device and verify files open.
  2. In Windows, check whether BitLocker/device encryption is enabled. Save the recovery key somewhere you can access if boot settings change.
  3. Use Windows Disk Management to shrink an NTFS partition when appropriate; do not guess how much free space is safe.
  4. Note whether Windows boots in UEFI mode; match the Linux installer boot mode.
  5. Confirm the exact disk and partition identifiers with lsblk or the installer.

Understand the layout

Typical UEFI systems already have an EFI System Partition (ESP). A dual-boot installation can share a properly configured ESP; do not create, delete or format one casually. A new Linux installation needs a suitable Linux root filesystem, and swap is optional depending on needs.

Non-destructive inspection

lsblk -o NAME,SIZE,FSTYPE,TYPE,MOUNTPOINTS
lsblk -f

These commands inspect disks but do not partition or format them.

After installing

Boot Linux, then boot Windows. Test both before celebrating. Store rescue media and partition/boot notes. Bootloader setup for Slackware 15.0 UEFI is documented in Slackware's README_UEFI.TXT and official guides.

DarkPC reminder: the machine on this site uses an existing Windows 11 and Slackware dual boot. Never paste partitioning commands from a stranger's hardware into your own.

Useful official references